Conclusion first: three metrics that matter
Judge a supplier on three verifiable metrics: Cr7C3 volume fraction (which sets overlay life under impact), hardness uniformity (which determines whether the plate develops early failure points) and weldability (which drives on-site installation cost). Marketing claims beyond these carry limited weight.
Metric 1: Cr7C3 volume fraction sets the wear ceiling
Wear resistance in a chromium carbide overlay comes from the Cr7C3 particles, not the matrix. Below roughly 20% volume fraction, abrasive grains plough out the particles and the surface wears flat rather than through; at around 30% the particles form a continuous hard skeleton and wear rate drops sharply. Require third-party test reports before signing, not just in-house data.
Metric 2: uniformity beats peak hardness
Standard overlay plate falls in the 58-65 HRC band. Reaching 65 HRC at a single point is easy; holding it across the whole plate is not. Hardness variation signals inclusions and porosity between weld passes, and those become crack initiation sites. Verify by multi-point sampling along the diagonal and ask for a test-point distribution chart.
Metric 3: weldability decides total cost
The plate ultimately gets welded into a liner and then installed. If the base material welds poorly, field preheating, backing and NDT can cost more than the plate price difference. Ask for a welding procedure qualification (WPS/PQR) before ordering, or request pre-drilled and bevelled finished parts directly.
Three traps to avoid
- Comparing unit price only: add welding, NDT and installation labour and the cheaper, poorly weldable plate often costs more.
- Comparing identical thickness specs: overlay and base thickness can be specified freely, so price per ton is misleading — compare by square metre of total thickness.
- Ignoring lead time: overlay plate is custom-welded, typically 5-20 days, while a shutdown window is often only 5-7 days. A missed delivery date is costlier than a price gap.
How to make an inquiry that gets comparable quotes
Provide in one message: working conditions (material type, particle size, moisture, running temperature), dimensions (finished flat size and hole positions), quantity (including spares) and delivery date (arrival, not ex-works). A complete inquiry normally returns comparable pricing and a sampling plan on the first round.
Enquiry and sampling
Send us the duty (material type, particle size, operating temperature), liner dimensions, quantity and required delivery date in one message, and you will receive a comparable quote, a sampling plan and a selection recommendation.
Key parameters at a glance
| Parameter | Value |
|---|---|
| Standard size (mm) | 1400×3400 / 1500×3000 / 2000×3000 |
| Process | Submerged Arc Welding (SAW) |
| Type | Flux-cored wire (FCAW/SAW) |