Do the arithmetic first

Compare four cost components: repair cost (dismantling, transport, overlay welding, inspection), downtime loss (power and output per hour), spare part cost (new roll purchase or rental) and difference in life (tons or hours actually run). For most projects the answer hinges on the second and fourth items, which are exactly the ones procurement usually leaves out.

Why off-line repair beats on-site welding

Off-line repair returns the roller to the workshop, where overlay welding, interpass temperature control and machining happen in a controlled environment free of site dust, moisture and confined-space variability. Crucially, the roller can then be machined back to its original profile and diameter — the technical precondition for treating a rebuilt roller as a substitute for a new one. Overlay without profile restoration lets the roller-to-table clearance drift, and output falls with it.

Roller surface material sets the life band

Vertical mill duty is dominated by continuous abrasion, so material selection should prioritise compression resistance, spalling resistance and high-temperature oxidation resistance. Among common surfacing materials, tungsten-carbide grades last longest under pure abrasion but cost more and tolerate impact poorly; chromium-bearing wear wires are more balanced where abrasion and light impact combine. Establish before selecting: maximum particle size, moisture content, and whether mechanical impact occurs at changeover.

When repair is the wrong answer

  • Deep cracks already present in the roll body: overlay cannot restore fatigue performance; replace the roll.
  • Third repair or beyond: repeated welding cycles accumulate heat damage, and economics usually favour replacement.
  • Wear beyond the designed removal allowance: insufficient remaining volume means rebuild quality cannot be guaranteed.

Three measurements that must be in the acceptance test

Overlay hardness distribution (multi-point around the roll circumference, typically 58-65 HRC with controlled variation), restored profile dimensions (diameter, taper, shaft runout) and surface finish (which drives material retention and throughput). Writing these three into the technical agreement prevents disputes far better than a vague "hardness shall comply" clause.

Enquiry and sampling

Send us the duty (material type, particle size, operating temperature), liner dimensions, quantity and required delivery date in one message, and you will receive a comparable quote, a sampling plan and a selection recommendation.

Key parameters at a glance

ParameterValue
Standard size (mm)1400×3400 / 1500×3000 / 2000×3000
ProcessSubmerged Arc Welding (SAW)
TypeFlux-cored wire (FCAW/SAW)