What hardness actually means

HRC measures resistance to indentation. Hard particles such as Cr7C3 resist abrasive cutting, so hardness correlates with abrasive wear resistance. But wear is rarely a single mechanism: abrasion, impact, corrosion and adhesive wear often act together, and raising hardness usually costs toughness and impact resistance.

Three material systems

  • High-chromium cast iron: 12%-30% Cr with high carbide content, excellent abrasive resistance, suited to continuous abrasion; impact resistance is modest and casting defects are a risk.
  • Overlay composite plate: high-chromium carbide layer metallurgically bonded to a low-carbon steel base — weldable, field-repairable and generally the best value, which is why it dominates current practice.
  • Martensitic wear steel (such as NM grades): hardened to martensite, high hardness with better impact behaviour than high-chromium iron, appropriate for moderate wear where machining is needed.

Choose the band by duty

  • Continuous fine-particle abrasion (cement and coal grinding): 58-62 HRC, favouring high-chromium overlay with roughly 30% Cr7C3 volume fraction.
  • Large lump impact plus wear (crushers, feed chutes): use chromium-bearing wear steel or a lower-hardness tough solution and add structural thickness; pure high-hardness plate chips at the edges here.
  • Mixed duty with limited shutdown access: a balanced 60-63 HRC solution that trades abrasion against impact.

Three costs of very high hardness

  • Weldability degrades: higher carbon and alloy content demands preheating and controlled cooling, raising installation cost.
  • Edge chipping risk: brittle high-hardness layers crack readily from impact at notches.
  • Non-linear cost growth: moving from 58 to 63 HRC raises alloy and machining cost noticeably faster than performance improves.

Why "harder is better" fails

A representative failure: a mine fitted 62 HRC plate in a feed chute taking large lump impact, and widespread edge chipping appeared within two months, making repair cost higher than simply switching to an impact-resistant wear steel. The plate grade was not matched to the actual failure mode. Deciding whether the dominant mechanism is wear or impact matters more than consulting a hardness table.

Enquiry and sampling

Send us the duty (material type, particle size, operating temperature), liner dimensions, quantity and required delivery date in one message, and you will receive a comparable quote, a sampling plan and a selection recommendation.

Key parameters at a glance

ParameterValue
Standard size (mm)1400×3400 / 1500×3000 / 2000×3000
ProcessSubmerged Arc Welding (SAW)
TypeFlux-cored wire (FCAW/SAW)